Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6. OPERATING INSTRUCTIONS
6.1 OVERVIEW
1 Switch
2 LED light
3 Shade
4 Floor cover
5 Suspension bracket
6.2 INSERTING BATTERIES
To insert batteries, hold the upper part of the camping lamp by the coloured ring
with one hand, and unscrew the floor cover (Position 4 in the overview) anticlock-
wise.
Insert the batteries in the battery compartment. Observe the correct polarity.
Place the floor cover back on the top part and turn it clockwise until tight.
6.3 OPERATION
6.3.1 POCKET LAMP
Press the switch for the pocket lamp mode (Position 1 in the overview). By pressing
several times, you can switch between light functions in the following sequence:
ON - dimmed - flashing - OFF.
6.3.2 ROOM OR TABLE LAMP
To use the mini camping lamp as a room or table lamp, hold the camping lamp by
the coloured ring with one hand, and turn the top part anticlockwise with the other
hand until it comes loose. The shade (Position 3 in the overview) will be clamped
by the spring Figure 4. By pressing several times, you can switch between light
functions in the following sequence: ON - dimmed - flashing - OFF.
To fold up the camping lamp, press the top part down. To lock it, hold the camping
lamp by the coloured ring with one hand, turn the top part clockwise with the
other until it locks into the coloured ring.
6.3.3 SUSPENSION BRACKET
The camping lamp can also be used as a suspended light with the suspension bracket.
7. MAINTENANCE AND CARE
7.1 MAINTENANCE
The LED mini camping lamp will not need maintenance if it is used correctly. If you
are not going to be using the camping lamp for a long period, remove the batteries
from the battery compartment.
7.2 CARE
Clean the LED mini camping lamp with a dry, soft cloth only. Do not use any ag-
gressive cleaning agents or solvent-based cleaners. Never allow liquids to ingress
into the device.
8. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be collected separately and dis-
posed of in an environmentally responsible manner for recycling. Please contact your community or city administration regarding
disposal options for electrical and electronic scrap.
9. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Deutschland
Figure 1:Top overview
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 2: Bottom overview
Figure 3: Inserting batteries
Figure 4: Clamping the shade
Figure 5: Folding up the lamp
Figure 6: Suspension bracket
info@eal-vertrieb.com
www.eal-vertrieb.com
5
Advertenties
Inhoudsopgave
