Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Advice regarding the first wash cycle
EN
After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack (if any).
Water softener settings
Before starting the first wash cycle, set the hardness lev-
el of
the water from the mains supply. (see chapter Rinse
aid and refined salt).
First load the softener tank with water, then introduce about
1 kg of salt. It is perfectly normal for water to flow out.
As soon as this procedure is complete, run a wash cycle.
Only use salt that has been specifically designed for dish-
washers.
After the salt has been poured into the machine, the LOW
SALT indicator light
If the salt container is not filled, the water softener and the
heating element may be damaged as a result.
Technical data
Dimensions
Capacity
Water supply pressure
Power supply voltage
Total absorbed power
Fuse
12
*
switches off.
width 59,5 cm
height 82 cm
depth 57 cm
13 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment (WEEE)
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
*
Only available in selected models.
(depending on the
.
Advertenties
Inhoudsopgave
