Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Electrical connection
The appliance is intended for
connection to alternating current. The
connection values for voltage (V) and
frequency (Hz) are given on the
nameplate in the cabinet.
Power must be connected via a wall
socket with switch. The wall socket
should be easily accessible.
All earthing requirements stipulated by
the local electricity authority must be
observed. The cabinet plug and wall
socket should then give correct
earthing. If in doubt, contact your local
supplier or an authorised electrician.
WARNING
– This appliance must
be earthed
The flexible cord (mains lead) fitted to
this appliance has three cores for use
with a 3-pin 13-amp or 3-pin 15-amp
plug. If a BS 1363 (13-amp) fused plug
is used, it should be fitted with a 13-
amp fuse.
IMPORTANT
The cores in this mains lead are
coloured in accordance with the
following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond
with the colour markings identifying the
terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW
core to the plug terminal marked „E" or
by an earth symbol, or coloured
GREEN or GREEN-AND-YELLOW.
Connect the BLUE core to the plug
terminal marked „N" or coloured
BLACK.
Connect the BROWN core to the plug
terminal marked „L" or coloured RED
Starting up the refrigerator
Start the refrigerator by plugging into a
wall socket.
If the mains lead has been damaged, it
must be replaced with a corresponding
type supplied by Gram A/S or a Gram
service centre.
The refrigerator incorporates a „stand-
by function" and in the display two
horizontal lines indicate that the power
supply has been connected.
Start the refrigerator by pressing the
start button
seconds, the green light emitting diode
(3) lights to indicate that the refrigerator
is switched on. The actual temperature
in the refrigerating compartment is
shown on the display
14
GB
(1). After approx. 5
s s s s s
(6).
Advertenties
Hoofdstukken
Inhoudsopgave
