eXact PipeCut V1000 Bedieningshandleiding pagina 11
Verberg thumbnails
Zie ook voor PipeCut V1000:
- Bedieningsinstructies (22 pagina's) ,
- Bedieningshandleiding (16 pagina's)
Inhoudsopgave
Advertenties
Operatie
Exact PipeCut V1000
Betjening af rørsav
Instruktioner
Før brug
Kontrollér at motorenheden står i oprejst
position, så det gule mærke på låseknappen er synlig.
Kontrollér at klingen passer til det rørmateriale, der skal
skæres.
Kontrollér at klingen sidder ordentlig fast, og at den er i
god tilstand.
Kontrollér at styrehjulene drejer.
Kontrollér at støttehjulene drejer.
Kontrollér at den nederste beskyttelsesskærm på klingen
fl ytter sig korrekt op og ned.
Kontrollér at det rør, der skal skæres, er tomt.
Connecting the Exact Pipe Cut V1000 to the main
power supply
Ensure that the mains voltage is the same as indicated
on the rating plate (Figure A/13)
Connect the Exact Pipe Cut V1000 to the power outlet
only after having checked these operating instructions.
Setting and marking the cutting point
Mark the cutting point, but remember that you have
to cut the duct so that you approach the duct seam
towards the closed side of it (Figure C). One mark is
enough. You do not need to mark all the way around
the duct.
Setting the supports for the duct to be cut
The supports for the duct are not delivered with the
Exact Pipe Cut V1000 but they are recommended
accessories. The supports maximise safety and
optimise the cutting result. They also reduce the size
of the required space for cutting the duct. The cutting
should always be done on a fl at surface.
Place the duct on three supports so that the middle
support is directly beneath where the duct is intended
to be cut (Figure B). Make sure that all of the supports
are in contact with the duct. Proper arrangements
prevent the saw blade from jamming in the duct in the
fi nal stage of the cutting process.
In case you are not using the supports you need to do
the following. Make sure that there is enough space for
the duct to rotate a full circle. Place the Exact Pipe Cut
V1000 so that the electric cord is hanging in front of
the duct from where you are standing (Figure C). Also
make sure that there is enough loose cord to ensure
free movement for the duct. If necessary, use a suitable
extension cord.
To start sawing
Open the safety screw (Figure D1) and adjust the
wheel pairs in the Pipe Cut steering device according
to the diameter of the duct by rotating the adjustment
knob on the back of the Pipe Cut (Fig. D2)
Fig B
Fig C
Fig D
11
nederlandse
Snijmarkering
Snijpunt
Advertenties
Inhoudsopgave
