Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Slide in the middle panel (fig. B).
2.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
Hook the seal in to the bottom of the panel again (fig. D).
4.
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
Malfunction table
Problem
Electrical operation is faulty (e.g. indicator
lamps no longer light up).
Liquid or thin batter runs to one side.
Appliance no longer works, ‹:‹‹ flashes
in the clock display.
‹:‹‹ flashes on the clock display,
"rrr"appears on the temperature display.
The temperature display shows, EXXX,
e.g. "„‹‹.
Appliance operation is not possible, D
and -†-appear in the temperature display.
Appliance operation is not possible, D
and -†˜ appear in the temperature dis-
play.
50
5.
6.
7.
8.
Do not use the oven again until the panels have been
correctly installed.
:
■
■
Possible cause
Circuit breaker faulty.
Appliance not installed level.
There was a power cut.
The power supply was inter-
rupted while the appliance was in
operation.
Internal fault in the appliance elec-
tronics.
The appliance controls have been
locked.
The appliance controls were
locked permanently.
Insert the uppermost panel at an angle to the back into the
brackets. Take care not to push the seal to the back (fig. E).
Insert the two small seals on the left and right of the panel
again (fig. F).
Put the cover back in place and screw it on.
Attach the oven door.
Risk of electric shock!
Work on the appliance electronics may only be performed by
a specialist.
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Note/remedy
Check fuses in the fuse box and replace if neces-
sary.
Check appliance installation (see the Installation
instructions).
Reset the time of day (see section: Electronic
clock).
Press the clock function button, reset the time of
day (see section: Electronic clock).
Press the clock function button. If the message
does not go out, pull out the mains plug and plug it
back in again after approx. 10 seconds.
Deactivate lock (see section: Childproof lock).
Deactivate permanent lock (see section: Childproof
lock).
Advertenties
Hoofdstukken
Inhoudsopgave
