Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ELECTRICAL CONNECTION
Connect the hob according to the wiring diagram.
This device is set for 1 x 1 phase (230V DC) and uses a so-called euro-plug. The group in the meter must be secured with at least 16
amps each. The connection cable must have a cross-section of at least 1.5 mm ².
ATTENTION : this hob is not suited for a different wiring diagram.
BLUE
YELLOW + GREEN
THE FITTING OF THE APPLIANCE
• Check that the cabinet and the cut-out meet the dimension and ventilation requirements.
• Remove the chips from the cutting job in the opening of the worktop and treat the saw ends of wooden or synthetic worktops with
sealing varnish if necessary, to prevent moisture causing the worktop to swell.
• Lay the hob upside down on the worktop.
• Fit the connecting cable to the appliance in compliance with requirements.
• Remove the protective layer from the sealing tape and apply the tape on the edge of the glass plate. Make sure to apply the tape
to the glass and not on the metal part. Do not stick the tape around the corners, but cut 4 separate pieces to seal the corners well.
Attention: any damage that occurs when not applying the tape has concequences for the warranty.
• Fit the supllied mounting brackets on the appliance.
• Turn the hob over and lay it in the recess.
• Connect the appliance to the mains. The appliance is ready for use.
• Check that it works properly. If the appliance has been wrongly connected either a bleep will sound or an error code will appear on
the displays.
REMOVING THE HOB
Disconnect the hob from the mains. Remove the hob by pushing it upwards from the bottom. Attention! Beware of damage to the
appliance! Do not try to remove it from the top.
28
•
English
BROWN
Advertenties
Inhoudsopgave
