Inhoudsopgave
Advertenties
Switch off without delay:
Push button ① twice.
Auto-Stop
To avoid that the hood will function during a too long
period, it will switch off automatically after 3 hours
(when no changes to the controls have been made).
Only the motor will turn off automatically. The lighting
will stay on.
Motor speed
To decrease speed levels push button ②. To increase
speed levels push button ⑤.
Three green Speed indicator lamps ③ indicate level
1 to 3, one red Speed indicator lamp ④ indicates the
level 'POWER'.
'POWER' is only used in case of excessive formation
of smoke, fumes or odours. Taking into account the
large volume of air which is extracted from the room at
this level, it's use should be limited.
'POWER' automatically reverts to level 3 after 6 min-
utes.
A self-rectifying thermal contact makes sure that
the motor is switched off when overheated. The mo-
tor will switch on again after is has cooled down. The
cause of the overheating needs to be determined. This
may be, for example, that the contents of the pan have
caught fire, the motor fan is blocked or an object is
(partly) closing off the exhaust opening.
3.2 Lightning
Press key ④ to switch the lighting on or off. The LED
lighting has a soft on/soft off mode, which means that
the lighting will evenly go on and off. When switching
on the lighting, this will always light up with full power
and it can also be used when the fan is off.
Dimming LED lighting
When the LED lighting has been switched on, it can be
dimmed by keeping key 4 pressed.
Change in colour temperature with LED-lighting
You can change the colour temperature of the LED-
lighting form 2700K (warm white) into 4000K (neutral
white). The description for changing this can be found
in section 4.4.
3.3 Remote control
1) illumination
2) increase speed levels
3) decrease speed levels
4) switch on / off
5) Novy-button - Not applicable
The remote control for hood is preinstalled and ready
for use.
Programming the remote control
If the set frequency disrupts other transmitters,
another code can be selected using the remote
control. There are 10 different codes.
Determine the code used
Simultaneously press
mote control flashes as many times as the selected
code (there are 10 code options in total).
Change the code:
• Simultaneously press
• The lamp on the remote control flashes as many
times as the selected code. Repeat this step until
you have reached the required code (there are 10
code options in total).
• Simultaneously press on the cookerhood
until the second green Speed indicator lamp is blink-
ing.
• Press the key
on the remote control within 10
seconds to confirm the settings. The cooker hood
and the remote control are now in line with each
other.
Change the batteries:
• For changing the batteries unscrew the plastic cov-
er, remove the old batteries and insert the new ones.
Pay attention to the polarity marking given in the
battery compartment
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in as
chemical waste.
Technical information
• Power supply: (2xAAA) batteries
• Frequence: 433.92Mhz
• Numbre of codes: 10
• Worktemperature: 0-50°C
• Dimensions: 110 x 50 x 19mm
and
.The lamp on the re-
and
.
+
EN 18
Advertenties
Inhoudsopgave
